Send and Receive Packets

The sender micro:bit and receiver micro:bit each have their own script, and they must be running at the same time.

• Connect two micro:bit modules to two USB ports with two USB cables.
• Open two separate browsers and navigate both to python.microbit.org.
• In each micro:bit Python Editor, click the three dots   ⋮   by the Send to micro:bit button, select Connect, and then set up each micro:bit connection.
• If you are part of a class, and have been assigned a channel, make sure to adjust the script’s channel=7 to your assigned channel before you save and flash the scripts.
• Enter, name, save, and flash the sender script countdown_sender into the sending micro:bit.
  (See Save & Edit Scripts and Flash Scripts with Python Editor.) 
• Enter, name, save, and flash the receiver script countdown_reciever into the receiving micro:bit.  It’s below the countdown_sender script.

Example Sender Script: countdown_sender

# countdown_sender

from microbit import *
import radio

radio.on()
radio.config(channel=7,length=50)

sleep(1000)

print("Countdown App")
print("micro:bit sender")

while True:
    text = input("Enter countdown start: ")
    value = int(text)
    message = input("Enter message after countdown: ")
    
    dictionary = {  }
    dictionary['start'] = value
    dictionary['after'] = message

    packet = str(dictionary)
    
    print("Send: ", packet)
    radio.send(packet)
    
    print()

Example Receiver Script: countdown_receiver

# countdown_receiver


from microbit import *
import radio

radio.on()
radio.config(channel=7,length=50)

sleep(1000)

print("Countdown App")
print("micro:bit receivern")

while True:
    packet = radio.receive()
    if packet is not None:
        print("Receive: ", packet)

        print()
        print("Parse: ")

        dictionary = eval(packet)

        value = dictionary['start']
        message = dictionary['after']
        
        print("value = ", value)
        print("message = ", message, "n")
        
        while value >= 0:
            print(value)
            sleep(1000)
            value = value - 1
            
        print(message)
        
        print()

• Click Show serial in both browsers.
• Follow the prompts in the sender micro:bit’s serial monitor for entering the countdown start value and the message to display afterwards.
• Check the receiver micro:bot’s serial monitor and verify that it completes the countdown and displays the message you entered.